Edit locations

The Show Districts Relationships to District Locations command creates an arrow pointing to its district for each location outside the area of its district. This command generates an analysis relationships, which can then be redesigned, made visible or invisible like any other analysis.

Shows the connection to the higher level of the locations via an analysis relationship (only available with several levels).

Select this command if you want to create a location for a territory and have no tables for it. In the dialog box you can select the number, the name and the corresponding territory under Properties and enter the basic block under Position, or the longitude and latitude under Position, or the longitude and latitude under Position using geocoded coordinates.

A special mode is started which allows you to place a new location with a mouse click. You can exit the mode by clicking the arrow button on the toolbar.

A special mouse pointer indicates this mode. The appearance of the mouse pointer tells you where the insertion of a new location would be allowed.

A prerequisite for insertion is that the mouse pointer is over a map showing the affected locations.

Here you can reload or modify the basic data of the territory locations. The Load Basic Data Wizard is started, in which you can specify the details.

A dialog opens in which you can specify the name of the locations. The following options are available:

• Naming sites according to their assigned territories
• Name sites after a basic building block in which they are geographically located.
• Name locations according to the next city of a city level.

Define the procedure according to which the new numbers are to be assigned. You can either assign the numbers according to geographical location (e.g. from North 1 to South n) or you can load an assignment table that contains the old and the new area number.

Create corresponding areas in the territory table for the existing locations. This allows you to transfer the numbering and naming of the sites to the territory and use them further.

Deletes all unassigned territory locations of the selected level.

Here you can reload or modify the assignment between the territories and the territory locations. The Load Assignment wizard is started, in which you can specify the details.

Select the update mode:

Reload All

This update mode allows you to dismap the existing assignment by importing a new assignment table. You can switch between imported and linked association data.

Supplement

This update mode allows you to retain the existing assignment and assign the bricks that have not yet been assigned to the correct territories using an assignment table. The update mode is only available if the assignment can be changed.

Replace

This mode allows you to update the assignment of territories. After importing the data, the existing assignments are dismaped if necessary and replaced with the newly loaded data. The update mode is only available if the assignment can be changed.

Consolidate

This update mode is only possible if you allowed multiple assignments when creating your structure. It must also be possible to change the assignment used. If your data is loaded for the existing assignment, both structures are retained.

Deletes all assignments between the basic building blocks and the territory locations.